AK Rifles banner

Zenitco installation

2 reading
2K views 5 replies 5 participants last post by  dvs  
#1 ·
Finally got a Zenitco rail pounded on. Only took 2 hours of sweat. My question, I accidentally grazed the barrel with my hammer a couple times. I didn’t really get it hard but I definitely made contact a few times. Should I be worried about barrel bending? I definitely feel like I would be if it was an ar15. Also those zenitco rails take some pounding…
 
#6 · (Edited)
you literally take the thing. place it on the right spot. use a small block of wood or a rubber hammer and smack it. if your receiver is russian or even romanian it will go in. i put one on a draco. fit just fine. on the siaga same thing. they wil get loose over time if you shave them.. if you watch the vids on zenitco they show it being done by a small woman....soo..