AK Rifles banner

1 - 4 of 4 Posts

·
Registered
Joined
·
664 Posts
Discussion Starter #1
Will the above mentioned fit on a stamped AK receiver?Using the standard trunnion already factory installed in the AK pistol.Thanks!
 

·
Registered
Joined
·
2,934 Posts
I believe it will. I remember reading that a fixed stock Polish Tantal uses the type 2 wood but stock if you want to be "correct" ( even though no fixed stock Tantals were fielded). So I'd assume milled and stamped furniture should all fit the same.
 

·
Technical Advisor
Joined
·
15,507 Posts
Sorta works. The milled is singe left side locking with the downturn angle. The right side locking holes in the receiver will be exposed.
It may not lock closed as the angle of the stock is downturned on the milled vs straight to the receicer line on the AKM double side locking.
It can be made to work depending on your build skills etc.
The Tantal is not an underfolder. I think you are thinking standard AKM rear block vs underfolder as OP is asking.
 
1 - 4 of 4 Posts
Top