AK Rifles banner

1 - 4 of 4 Posts

·
Registered
Joined
·
115 Posts
Discussion Starter · #1 ·
Anybody have a 7.62x39 bullet guide..
Building a milled Yugo m70 so not sure if stamped AK's and milled guides will interchange?

Thanks!
 

·
Technical Advisor
Joined
·
16,054 Posts
One word of caution. Although the 7.62 are al the same for standard AK etc. Be sure to install the bullet guide (it may require some light file fitting). Then take the bolt & carrier and hand cycle to be sure the ramp in the guide is turning the bolt head and it rotates freely into lockup.

Nothing worse than riveting it in and finding the ramp or the leading bolt lug surface is a bit too tight. Easier to adjust the ramp before it gets riveted in place. :)
 
1 - 4 of 4 Posts
Top