AK Rifles banner
1 - 3 of 3 Posts

· Registered
Joined
·
28 Posts
Discussion Starter · #1 ·
I recently purchased a full auto KRINK. It is registered as 5.45 x 39 and has this stamped under the ejection port. However, on the other side of the Poly Tech receiver is stamped 5.56x45. SWD Inc is listed as the manufacturer/importer on the Form III registration. The gun is obviously chambered for 5.45 as it shoots flawlessly. I am assuming that SWD simply used a Poly Tech 5.56 receiver for the build. Apparently using this receiver for the build made no difference in the final product.

Has anybody else seen this type of build?
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top