AK Rifles banner
1 - 4 of 4 Posts

·
Registered
Joined
·
577 Posts
Discussion Starter · #1 ·
I searched for this but couldnt find it. I am going to use a Tapco G2 trigger. What, if anything, do I need to do special on that tantal. I dont really care about the left side selector working, but I do want it to be in place so theres no just a hole in the receiver :D

Please let me know

Thanks!

-Ryan
 

·
Registered
Joined
·
32 Posts
Hello Trucking, I used a G2 in my tantal and also din't care about any sort of actual function out of it other then it actually being on there to look the part. The mod I needed for everything to play together was to grind off one of the little posts on the shaft attatched to the lever. It was the one furthest away from the lever. The one close to the lever needs to stay since it holds the lever on the receiver. Good luck and congrats on the Tantal!
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top