AK Rifles banner

SPF Polish Underfolder Parts Set

424 Views 3 Replies 3 Participants Last post by  wkendwarrior2003
SPF Polish Underfolder Parts Set

WTS a Polish underfolder parts kit I picked up a few years back. The trunion has the 11 in a circle with 1984 right after it, followed by SC14455. The trunion does not match the rest of the serial numbered parts. The markings on the rest of the parts are as follows:

Gas tube-0208
Dust cover-0208
Bolt carrier-20208
Recoil spring-0208

All of the parts are as I received them from the distributor (I think it was Dan's Sporting Goods). These parts don't look like they were used much, the parts have most of the original finish still on them except for a few spots that must have been nicked or rubbed against each other during demil and storage.

After checking the bore several times I think that there is some light pitting near the chamber end of the bore. I kind of wonder how this is possible with a chrome bore and all, but I would rather err on the side of caution and make this known now. I really do not think this would detract at all from the accuracy of the barrel. The rifling is sharp and the muzzle passes the bullet test.

The handguard, gas tube and the pistol grip don't look like they were used at all.


http://i286.photobucket.com/albums/ll86 ... rtsset.jpg

http://i286.photobucket.com/albums/ll86 ... runion.jpg

http://i286.photobucket.com/albums/ll86 ... lGrip2.jpg

http://i286.photobucket.com/albums/ll86 ... etTest.jpg

I am asking $295 (in a postal money order) shipped and insured for this kit. The first unconditional "I'll take it" posted HERE gets the kit. If you have any questions please ask and I'll do my best to answer in a timely fashion. Thanks
See less See more
1 - 4 of 4 Posts
PMKMS parts

If you can take paypal,
then I'll take it.
I'll take it, if SmartyKRS1 doesn't get it.
buckshot27 said:
I'll take it, if SmartyKRS1 doesn't get it.
SPF to buckshot27.
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.