AK Rifles banner

Status
Not open for further replies.
1 - 8 of 8 Posts

·
Registered
Joined
·
5,057 Posts
Discussion Starter · #1 ·
1975 Izhmash underolder kit, PLO kit. Factory force match bolt and carrier to trunnion (electro penciled). Topcover was slightly pitted so I replaced it with a new Maadi cover. I will include the old cover. Rear trunnion was cut so I replaced it with a milled Polish trunnion, you cannot tell the difference.

Furniture:
Lower handguard was trashed so I sent one of the good Maadi lowers to Zrecto to be recontoured and refinished. Upper is russian, pistol grip is Zrecto USA.

Receiver is NDS serial # matched to trunnion. Engraving by POHF.

Bore is shiny and passes bullet test. Underfolder is tight w/zero slop.

Finish is Duracote. Has small wear mark on the tip of the front sight base and the selector lever mark where some dumbass (me) couldn't wait.

Compliance parts are G2 FCG, receiver, pistol grip and floor plate.

Sling is good but has some crud as seen in the pictures.

Does not include mag and bayonet in picture!

$1200 + shipping/insurance USPS to your FFL. I ship in a plastic padded gun case.











 

·
Registered
Joined
·
5,290 Posts
Man.. This is sweet. The exact rifle I'm building. If I didn't have all the parts already this would be gone.

Bump for a killer rilfe.
 

·
Registered
Joined
·
1,129 Posts
if i had money! BigAl if you wait a few months i would probably have some money for one of these fine AKs you've been selling.
 

·
Registered
Joined
·
977 Posts
I just got to see this rifle in person. It is teriffic.
I don't think you wil find a better detailed rifle out there, especially at this good of a price. It's almost to pretty to shoot.
:shock:
 
1 - 8 of 8 Posts
Status
Not open for further replies.
Top