AK Rifles banner

1 - 11 of 11 Posts

·
Registered
Joined
·
696 Posts
Discussion Starter #1
I promise I will post a 3d pic of the Flats with all the correct military dimples later this week. I have taken alot of time to this project right so it has encountered countless delays.

To hold you over till I can show you a 3d model of the flats here are the prints for the AKM lower rails.


 

·
Registered
Joined
·
553 Posts
NICE!! Cant wait to see them!
 

·
Registered
Joined
·
696 Posts
Discussion Starter #9
Re:

I would like to point out the surfaces on the lower rails that are spot welded to the inside of the receiver are milled down to the same thickness of the receiver while the tops of the rails remain thicker. This will be incorporated into my rails since they were reverse engineered from factory lower rails.
 

·
Registered
Joined
·
696 Posts
Discussion Starter #11
Re: EXP*

Kendwell said:
Look like bank account draining. Hope yugo is in your plans also
Bank account draining for me but competetively priced for you. :wink:

We have a AMD65 flat in the immediate future. I have had a hard time finding a correct yugo receiver to copy and make a flat out of but I do plan on having a fixed stock available. AK74s with the correct offset y and trigger pin hump are next on the engineering block.
 
1 - 11 of 11 Posts
Top