AK Rifles banner

1 - 3 of 3 Posts

·
Registered
Joined
·
188 Posts
Discussion Starter · #1 ·
I assembled an AMD build today, and when testing the safety I found that the tang on the selector is too short to block the trigger. When you pull the trigger, it won't stop against the tang until the sear has already tripped. Then I tried a selector from a Romy 63, and everything worked just fine. Both are original full auto selectors, but there's obviously a difference between them.

Now I need to order a new selector for this build, but I need to make sure it's a type that works. A Romanian is obviously a safe choice, but does anybody know what else I can use, and which ones to avoid?
 

·
Registered
Joined
·
188 Posts
Discussion Starter · #3 ·
Yes, and I was thinking about getting the enhanced gen 2 while I'm at it. Still, I'm curious about this problem so am I the only one who has run into it?
 
1 - 3 of 3 Posts
Top