AK Rifles banner
21 - 24 of 24 Posts

·
Registered
In the forest at end of a long dirt road in Ga
Joined
·
397 Posts
I assume that brace mounts by drilling and tapping a hole in the rear trunion. Personally, I would avoid that. It could hurt future resale value.
One small hole in the rear after brace is removed -VS- 4 large holes in the sides of the receiver after a UF stock is removed.. Okay , LOL
 

·
Registered
Joined
·
3,162 Posts
One small hole in the rear after brace is removed -VS- 4 large holes in the sides of the receiver after a UF stock is removed.. Okay , LOL
My point was that if you brace it, you may very likely sell it later, harming value. If you install a UF stock, it's most likely an SBR, and very few people resell NFA items.
 

·
Registered
Joined
·
57 Posts
Totally worth a form 1!
The Draco-C is only worth the cost of milling the trunnion, over the regular model. Super simple SBR:)

 
21 - 24 of 24 Posts
Top