AK Rifles banner

1 - 2 of 2 Posts

·
Registered
Joined
·
874 Posts
Discussion Starter · #1 ·
The last couple of Bulgy 74 trigger guards I've done with the ak builder trigger guard jig, the bends in the guard are such that it does not sit flush on the jig. In consequence, once riveted the rivet heads are not sitting flush against the guard. The last two I've done I've had to drill out and re-rivet. Anyone dealt with this before?
 

·
Registered
Joined
·
4,464 Posts
I have had that issue too, especially with receivers that have pistol grip reinforcement plate. What I do is rivet the 4 in the front first the rivet the back one last. The little plate that holds the rear rivet causes the receiver to tilt forward on mine.
 
1 - 2 of 2 Posts
Top