AK Rifles banner

1 - 3 of 3 Posts

·
Registered
Joined
·
265 Posts
Discussion Starter · #1 ·
so most muzzle breaks and FH's are for M14 X 1 LH, what does the raw steel need to start out if you were going to order a TAT and M14 X 1 LH die kit to thread the barrel....I have a barrel I'm shortening, I'm gonna have a guy turn it on the lathe and get it ready to cut the threads

I measured a Romanian kit after removing the slant break and it was just a hair under 14 mm ( 13.78 ) ...is this correct ??...I guess I would be ok to have him turn it down to 14 mm ??
 

·
Registered
Joined
·
4,359 Posts
Sorry for not having the translation, but my hybrid brain uses .550" as the standard muzzle diameter to thread to 14x1mm LH.
 
1 - 3 of 3 Posts
Top