AK Rifles banner

PARLEC 6" lock down mill vise??

408 Views 3 Replies 3 Participants Last post by  Tomovich
Thinking of getting one for the mill..............anyone have any experience? KURT's are SO much more $$$$

TIA
1 - 4 of 4 Posts
All I have ever used are Kurts. Even on tombstones for CNCs.


Although I have considered a similar but cheap import for a drillpress vise, big enough to hold a Holley.


Feeling better?
I've used one of the chinese imports millvise [around $50.00] they work, but because of how they are made you have to get used to them. I got a box of end mills and took a piece of scrap to practice on before touching my kit. I found that moving the table/part the same direction each pass is best.These vises are a bit on the crude side.
Prototype Services said:
All I have ever used are Kurts. Even on tombstones for CNCs.


Although I have considered a similar but cheap import for a drillpress vise, big enough to hold a Holley.


Feeling better?
My heart is still beating and that's always good. :smile:

Any one else on PARLEC's?? I hate to buy a KURT that's almost as expensive as my bench mill. :neutral:
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top