AK Rifles banner
1 - 2 of 2 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Bent my first flat yesterday.
Apparently i need to tweak the alignment some ..Anyway my bent receiver trigger guard holes are not centered .I have one closer to the edge than the other.Will this affect the bolt travel/lockup on head space or if the triggerguard can be riveted in place, will it function properly? Don't want to buy another flat yet.
Thanks
 

·
Registered
Joined
·
1,429 Posts
You should be fine. I have come to notice the ak-builder dies have a slight amount of slop in them. For me at least ive noticed the trigger guard holes on the selector side come out closer. I havent had any issues yet with any of my builds some have a few thousand rounds through them with no issues.
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top