AK Rifles banner

1 - 3 of 3 Posts

·
Registered
Joined
·
13 Posts
Discussion Starter #1 (Edited)
1. They don't include directions and I, at least, ended up installing it wrong by screwing in the bolt from the outside of the receiver, thinking that the bolt was too small (it doesn't screw into the threaded hole for the bolt in the stock), and then almost sending it back to Krebs. The bolt goes inside the receiver, and the washer in between the bolt and the inside of said receiver. They mention this in the description of the product on their website but that's it.

2. They don't include the necessary hex wrench and if you have one of these folding-pocket-knife-like affairs, like I do, you're going to have a hell of a time getting in the receiver with it and tightening the bolt, and it does require a good bit of tightening because the washer included is a crush washer (I think?) that's supposed to be crushed (I hope? because I did) between the bolt head and receiver.
 

·
Registered
Joined
·
13 Posts
Discussion Starter #3
1 - 3 of 3 Posts
Top