AK Rifles banner

1 - 8 of 8 Posts

·
Registered
Joined
·
1,359 Posts
Yes.

Open up the LH safety pivot hole & slot the underside of the receiver(do this before adding the trigger guard).

I don't have a pic handy, but it's a very straightforward job.
 

·
Registered
Joined
·
549 Posts
Would need to modify the pistol grip as well, to allow the selector to pivot and so that it wouldnt cover up the slot. Might not be an issue for some grips. There was some aftermarket grip (I think) that was made for this, with the cut out in it and "0 1 30" markings. Dont think they are available mainstream anymore.
 

·
Registered
Joined
·
3,359 Posts
sgt5th said:
Would need to modify the pistol grip as well, to allow the selector to pivot and so that it wouldnt cover up the slot. Might not be an issue for some grips. There was some aftermarket grip (I think) that was made for this, with the cut out in it and "0 1 30" markings. Dont think they are available mainstream anymore.
Those were Bulgarian, K-var used to carry them.
 

·
Banned
Joined
·
2,035 Posts
only thing I would add to what's been said is to solidly spot weld in a pistol grip re-enforcment plate . They get a little light on the bottom after you cut clearance for the left side selector .
 
1 - 8 of 8 Posts
Top