AK Rifles banner

1 - 7 of 7 Posts

·
Registered
Joined
·
4,701 Posts
It should be just fine..I would make sure no metal is sticking up/burrs before you shoot it though..
 

·
Registered
Joined
·
392 Posts
Discussion Starter #3
ak_nut said:
It should be just fine..I would make sure no metal is sticking up/burrs before you shoot it though..

I didnt see any burrs or anything but will give it a good look over again before I shoot it. The mark may have been there already because im not quite sure how the rod would leave that mark the way that it was stuck inside. The cleaning rod was very slightly bent but im not sure a slightly bent rod could leave a mark like that. I could be wrong though.
 

·
Registered
Joined
·
392 Posts
Discussion Starter #7
machineguneddie said:
-Todd- said:
aldfaa said:
Are you seeing the gas port?

:lol: Hell I might be, i'll have to look at it again later.
it wouldnt be the first time somebody made that mistake :doh:


Really? Im bad at always expecting the worst to happen. I looked at it again and it does appear to be around that area where I would think the gas port would be so that might be what im seeing. :razz:
 
1 - 7 of 7 Posts
Top