AK Rifles banner

1 - 4 of 4 Posts

·
Registered
Joined
·
20 Posts
Discussion Starter #1
Anybody else had feed problems. Both my guns have impact problems against the barrel face. Any suggestions? I compared it to an origional and it seems that the two receivers have a little less metal in the feed ramp area and don't lift the rounds high enough to enter the barrel opening but impact on the lower face. I have tried over 10 new mags and only one is even a little reliable. :mad:
 

·
Registered
Joined
·
371 Posts
There was a post on here where they (ORF) was fixing feeding issues with the receiver. If your receiver number was below 120, it needed to be sent back for additional work, and ORF covered shipping. Receivers above 120 did not need any additional work.

Is yours below 120? Has it been sent in for the additional work?
 

·
Registered
Joined
·
20 Posts
Discussion Starter #4
Good to go!!!!

Had a chance to talk to Phil @ ORF on Saturday. I polished and gave a slight chamfer/radius to the barrel face. I can even feed hollow points with either gun and any magazine. No adverse effect on the used cases that I could discern in over 150 rounds fired.
 
1 - 4 of 4 Posts
Top