AK Rifles banner
1 - 5 of 5 Posts

·
Registered
Joined
·
3 Posts
Discussion Starter · #1 ·
Looking at a number of different layout templates for the 80% receiver blank, I find a difference in the position of the 2 FCG holes. All templates agree that the hammer is located 4.90" from the rear and the trigger 3.35". Most templates place the hammer 1.1" down from the top rail, and the trigger 1.38". Some, however, place the hammer 1.083" down and the trigger 1.358". What is the consensus on which is correct? Thanks.
 

·
Registered
Joined
·
2,601 Posts
russian milled t3 stub: 1.095 and 1.364
polish milled t3 stub: 1.060 and 1.357
bulgarian-built ISD BSR-74 rifle: 1,065 and 1.350
russain saiga IZ-240 rifle: 1.100 and 1.370
 

·
Registered
Joined
·
3 Posts
Discussion Starter · #5 ·
russian milled t3 stub: 1.095 and 1.364
polish milled t3 stub: 1.060 and 1.357
bulgarian-built ISD BSR-74 rifle: 1,065 and 1.350
russain saiga IZ-240 rifle: 1.100 and 1.370
Thanks very much for this info. I will average these readings; I probably can't lay out closer than 5/100ths of an inch anyway!
 
1 - 5 of 5 Posts
Top