AK Rifles banner

1 - 6 of 6 Posts

·
Registered
Joined
·
2,056 Posts
Discussion Starter #1
I have a pushbutton side folding stock that had been spot welded from Century during the Evil days. The spot weld has been ground down so the stock now folds, but it's very stiff. Can I drive the pin out to disassemble the stock, smooth down the weld scars, and redrive the pin safely and effectively?
 

·
Registered
Joined
·
2,935 Posts
i think the pushbuttons are all stiff.i have one on my romy g build and it needs a good push to close.i heard the levers folded a little easier.
 

·
Registered
Joined
·
2,056 Posts
Discussion Starter #4
Romanian. I have a couple of these, and this one is way too stiff. It's very difficult to open the stock.
 
G

·
Guest
Joined
·
0 Posts
Wakko said:
Romanian. I have a couple of these, and this one is way too stiff. It's very difficult to open the stock.
Maybe you can just use a little CLP? Probably the less you open/fold it the better. I have a Romy folder that worked itself loose and the pin that keeps the button up fell out. Now it flaps in the breeze.
 

·
Registered
Joined
·
2,110 Posts
Yes, they are easy to disassemble, removing the pin, you remove the arm, and can then clean up the welds, it will loosen with use, but a good lock open or closed is what your after.
 
1 - 6 of 6 Posts
Top