AK Rifles banner

1 - 7 of 7 Posts

·
Registered
Joined
·
4,464 Posts
Discussion Starter · #1 ·


Any tips on how or what pin to use to hold the spring and pin in place.
 

·
Registered
Joined
·
1,357 Posts
That doesnt look like a detent to me. Should have slot milled into it for the cross pin to be able to pass over one side once it is installed. Like this
 

·
Registered
Joined
·
4,464 Posts
Discussion Starter · #3 ·
From what I have figured out with this one is the pin goes in then the spring and the pin is inserted and retains both. The small pin is too big so what to use?
 

·
Technical Advisor
Joined
·
16,054 Posts
Shove on the spring with a round stock that is smaller diameter than the cross pin. Insert the cross pin and trap the spring and pull out the small diameter nail etc., from the rear. You can use an appropriate roll pin for the cross pin retainer.
 

·
Registered
Joined
·
4,464 Posts
Discussion Starter · #7 ·
AKBLUE said:
Shove on the spring with a round stock that is smaller diameter than the cross pin. Insert the cross pin and trap the spring and pull out the small diameter nail etc., from the rear. You can use an appropriate roll pin for the ross pin retainer.
I have been thinking about using a roll pin. Thanks.
 
1 - 7 of 7 Posts
Top