AK Rifles banner

1 - 5 of 5 Posts

·
Registered
Joined
·
88 Posts
Discussion Starter · #1 ·
I am new at this and getting ready to build my first kit. I have purchased a NDS-1 receiver and the required rivets for the trunions. Every thing is demilled and ready to go, except I have one question.

Do I need to buy a Cross Member Bushing and Rivet?

I see these in tapco and other places and know I do not have one, and havent seen referance to it in any of the build tutorials or the DVD i watched.

Thanks for any help!!!
 

·
Registered
Joined
·
2,037 Posts
Nope, pre-installed by nodak. Isn't it? (Check your receiver)

If not, I recommend one from ak-builder.com

Good Luck!
 

·
Registered
Joined
·
7,707 Posts
All the different NDS receivers I have bought all had the cross member rivet/bushing already installed.
 

·
Registered
Joined
·
1,451 Posts
you can buy the cross member tubes by the foot,about 3+ bucks.just cut em to length and heat treat em.
Aircraft Spruce sells the center support tubes

http://www.aircraftspruce.com/catalo...tubing_un1.php
Part No Description
03-00300 1/4" Outside diameter 3/16" or 5/32" Inside Diameter 4130 tubes
 
1 - 5 of 5 Posts
Top