AK Rifles banner

1 - 9 of 9 Posts

·
Registered
Joined
·
2,935 Posts
Discussion Starter #1
i'm always meesing and tinkering with my guns,mostly because i can't get to the range as much as i would like.anyway,z_recto helped me build my romy g last summer and its great.i carved up the hg's and used duplicolor for the receiver.it looked good and all,but the finish didn't go with the hg's at all :sad: so i got some 3m green pads and took some of the finish off.not completly gone,but definatly worn.next is a g2.i have a century fcg in and thought it was ok.that was until i put a g2 in my aes10b,now i have to swap it out.how'd i do?


 

·
Registered
Joined
·
2,935 Posts
Discussion Starter #3
i was thinking of some ironwood ones.those are just the hg's i had from the kit.someone did a damn nice job cutting off the forward pgrip.you'd never know it until you look inside the hg.
 

·
Registered
Joined
·
2,935 Posts
Discussion Starter #5
everything.the finish was real nice and dark on the rest of the stuff.i'll make my next build nice and new looking.
 

·
Registered
Joined
·
2,935 Posts
Discussion Starter #7
Templar said:
Straight outta Bagdhad!!!

:thumbsup:

Looking good man!
thanks man.now if i can get the damned sight drum to move,i'd be set.
 

·
Registered
Joined
·
1,296 Posts
crazychris said:
now if i can get the damned sight drum to move,i'd be set.
Looks great Chris.

Get a "pencil" torch (runs on butane) give the area around the drum
some heat(not alot),then hit it with some "PB Blaster", repeat if needed.
You don't want to heat the drum,just the area around it!!!!!
She will break loose.
 

·
Registered
Joined
·
2,935 Posts
Discussion Starter #9
thanks tom.i'll give it a shot next time out to the range.now that this is 100% done,its time to start working on my romy g underfolder.
 
1 - 9 of 9 Posts
Top