AK Rifles banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2 Posts
Discussion Starter · #1 ·
Going to make a CNC steel front trunnion for an AK build, can I make the bullet guide part of the trunnion, all one piece?
 

·
Registered
Joined
·
167 Posts
I don't know why it wasn't done like that to begin with, so why not? I figure the only reason why it's a separate part would be manufacturing/tooling issues, so if you can integrate it with the trunnion: More power to you. Looking forward to test results.
 

·
Registered
Joined
·
10 Posts
The polish v-project trunnions AoA had a few years ago have integral bullet guides.Ive used one for a build and it worked fine.
20210506_015017.jpg
20210506_014945.jpg
 
1 - 3 of 3 Posts
Top