AK Rifles banner

1 - 5 of 5 Posts

·
Registered
Joined
·
343 Posts
Discussion Starter · #1 · (Edited)
I need to bump the front sight on my M95 Yugo. Dont want to order and wait for a proper tool. Any good ideas on an alternate tool to adjust the front sight? I do have some C clamps and a vice if that will helps. Point of aim is where the case is on the tape. 100 yrds iron sights.
 

Attachments

·
Registered
Joined
·
4,381 Posts
sure, support the front sight block on something just below the front sight adjustment drum. Take a piece of steel or brass casing and a hammer(or any hammering device), put the primer end of the case on the adjustment drum and give it a whack.
 

·
Registered
Joined
·
2,654 Posts
Use a socket and a quality C-clamp. Place the socket over the sight drum and use the clamp to press it the direction you need.
 

·
Registered
Joined
·
3,599 Posts
Use a socket and a quality C-clamp. Place the socket over the sight drum and use the clamp to press it the direction you need.
This is best idea
 
1 - 5 of 5 Posts
Top