AK Rifles banner

1 - 11 of 11 Posts

·
Registered
Joined
·
265 Posts
ok will wait for pics, but tell us some more, is that gonna be a re-weld on a milled kit ??
 

·
Registered
Joined
·
111 Posts
Discussion Starter #3 (Edited)
ok will wait for pics, but tell us some more, is that gonna be a re-weld on a milled kit ??

Yep! Since it's blow back there is no worries about a failure of the locking lugs or anything like that, so it's a good use of those APEX torch cut receivers. it's not much different then
building a ppsh/pps as far as welding goes.
 

·
Registered
Joined
·
265 Posts
Yep! Since it's blow back there is no worries about a failure of the locking lugs or anything like that, so it's a good use of those APEX torch cut receivers.
will you be selling the mag well by themselves ?? if so how much ??
 

·
Registered
Joined
·
111 Posts
Discussion Starter #7 (Edited)
You can see how much material was removed from the "stub" for the pistol cartridge.

MP5 mags need no ramps/guides to feed, and can be moved closer to the chamber.
 
1 - 11 of 11 Posts
Top