Joined
·
708 Posts
...
...
1 - 4 of 4 Posts
Joined
·
708 Posts
Re: Stamped Bulgy Frankenbuild.
It's had 300 rnds put through it since the build. Action is free as my Milled, no issues at all, aside from I need to cut the Ejector's face more "square" It tosses 1 in 30 back into the topcover on ejection. It still clears the rifle, just can hear the PING of it bouncing off the topcover. Ejector is slightly canted towards the rear of the rifle..niothing 30 seconds with a sanding drum on my dremel cannot fix.
:animak: :animak:
It's had 300 rnds put through it since the build. Action is free as my Milled, no issues at all, aside from I need to cut the Ejector's face more "square" It tosses 1 in 30 back into the topcover on ejection. It still clears the rifle, just can hear the PING of it bouncing off the topcover. Ejector is slightly canted towards the rear of the rifle..niothing 30 seconds with a sanding drum on my dremel cannot fix.
:animak: :animak:
Joined
·
3,164 Posts
Re: Stamped Bulgy Frankenbuild.
That's pretty cool. Now that I looked at it a bit. Looks like a flat build, missing center support.. no need for reply. :grin:
Wood set looks good, upper wood is cool with the vents. Do you fire that with a blindfold. :mrgreen: Clean looking build.
That's pretty cool. Now that I looked at it a bit. Looks like a flat build, missing center support.. no need for reply. :grin:
Wood set looks good, upper wood is cool with the vents. Do you fire that with a blindfold. :mrgreen: Clean looking build.
1 - 4 of 4 Posts
