Tried to take better photos last night.
Plans call for a 80% lower with Colt commercial M16A2 engraving to replace the existing lower.
I want to have John Thomas remove the phantom and install a spacer and A2 flash hider. I have the correct extension tube nut and Colt tube.
Also have the Surefire part number M14 mount for the old school light.
I need a worn military A2 grip for it. It is amazing how hard something like that is to find. I have a bunch of commercial A2 grips and could wear one down if needed.
I've not seen another sling just like this one - found it in a bin at a gun show years ago.
For $18, you can't beat it.
Hopefully it's good metal bit something that dulls from being looked at
Sent from my XT1650 using Tapatalk
If its Harbor Freight, its probably made in China, but again, for $18, it would make a great little camp axe.
Couple guys online said that the edge is properly heat-treated.
I will tell you that the spike was super soft. It came off like butter
Sent from my SM-G930V using Tapatalk
As long as it works for the fire pit out back, its all good.
Looks great ^^^^^^^^^^^^^^^^^^^^^^^^^
All my Heavy & Socom Barrel Clones Builds over the summer .
((( All built to fit my needs )))
From top down
#1 - 20'' Stag Arms Lefty HBAR Clone
#2 - 16'' DI LWRC CHF Barrel w/ Colt Upper receiver & BCG / Colt M4 Lower Clone
#3 - 11.5''FBI CQB Colt Socom barrel on Stag Arms Lefty Upper receiver & BCG 7'' LWRC FF rail system /Anderson pistol Lower w/ Blade & tube / Clone
#4 - 10.3'' Socom barrel cut down from a colt 14.5'' M4A1 / on Stag Arm Lefty & BCG / 9'' LWRC FF rail system / Diamond sites on a Colt CR pistol Lower & SB3 Brace Clone / Hillary Clinton behind bar's Pmag
That PMag is greatness.