Looking for a Toth trigger guard installation tool. I only need it for 1 trigger guard on a Saiga conversion. I'm hoping I can find one to borrow or rent. I can buy one if someone has one laying around and they aren't using it. Thanks
You donít really need one
Unless youíre building a bunch of AKs everyday thereís zero reason to mash them all at once.
Make one of these ... long enough to bottom in vice.
Punch ... grind a notch to clear the rails.
Third hand is helpful
Simply hold receiver assembly with the rivet head in that tool and mash the inside w the hammer and punch.
The one I made is simply drilled in the end ... no need to be half round.
It hasnít misshapen one rivet head ever.
It needs the flat on the side to get close to the guard.
Iv done a dozen AKs this way.